Command Line Reference

The following command line options are supported by AutoIndex:

--in=infilename: Specifies the name of the XML input file to be indexed.
--out=outfilename: Specifies the name of the new XML file to create.
--scan=source-filename: Specifies that source-filename should be scanned for terms to index.
--script=script-filename: Specifies the name of the script file to process.
--no-duplicates: If a term occurs more than once in the same section, then include only one index entry.
--internal-index: Specifies that AutoIndex should generate the actual indexes rather than inserting <indexterm>s and leaving index generation to the XSL stylesheets.
--no-section-names: Prevents AutoIndex from using section names as index entries.
--prefix=pathname: Specifies a directory to apply as a prefix to all relative file paths in the script file.
--index-type=element-name: Specifies the name of the XML element to enclose internally generated indexes in: defaults to section, but could equally be appendix or chapter or some other block level element that has a formal title.